The Options can be found in MENU > Setup > Options.
These settings relate to control surface-specific options such as Query configuration and Follow Modes.
Surface Options are found in MENU > Setup > Options > SURFACE tab.
Select/Solo/Query Follow Options
The Follow Setup section allows linking, or Following, of various button combinations on the Fader Tiles. This allows, for example, paths to be Soloed automatically whenever their Select button is pressed (or vice versa).
To configure Follow modes, first enable the Edit button.
Three rows correspond to the hardware Select, Solo and Q (Query) buttons on the Fader Tiles. The columns refer to which button should follow, on press of the hardware button. Columns are arranged by path type (Channels, Stems, Auxes etc.), allowing different Follow modes for different path types.
Enable the buttons in the grid corresponding to which function (column) you would like to follow on press of a hardware button (row). For example, to enable Solo Follow Select for Auxes, locate the Solo column in the Aux / *Aux section and press the button in the intersection between that column and the Select row.
Use the buttons in the Edit row and column of the grid to select entire rows and columns, then use the Set All, Clear All or Toggle buttons to alter the state of the selection.